T/MonXM 4.7 User Manual

UM-TMN-470

Section Five - Configuring Remote Access

5-11

D-SK-159-10A-00

Cursor

Movement

Keys

When selecting the cursor movement keys on a remote terminal, the

following format must be used:

Hold down the key and press P then the corresponding number of

cursor action desired (refer to the keypad diagram above).

Example:

<CTRL> P 7 Home. Moves to the first screen when viewing in

monitor mode.

<CTRL> P 3 PgDn. Moves down one screen when viewing in

monitor mode.

Note:

If you are using an IBM-Type keyboard and want to use the

numeric keypad, be sure the 57O key is ON.

The Following operations may be initiated from the Alarm Printer

Logging Control window:

F1 Toggle Printer Cut Off.

When you are in this mode, F1 will toggle printer cut

off. This action can be seen by the “P:X” symbols in

the Page Index window.

Fig. 5.11 - Alarm Printer Logging window

Alarm Printer

Logging

Note:

If you are using a

T/Remote WorkStation,

normal function keys may

be used as though they

were the main T/MonXM

system’s function keys.

The Alarm Printer Logging window will allow the remote user to

log alarms to the printer. The user can enable Alarm Printer Logging

by pressing CTRL F1 from the remote Monitor Mode screen. When

the Alarm Printer Logging window appears (in the lower left corner

of the screen) the user is requested to respond to printer logging

questions.

The Alarm Printer Logging window appears as follows:

Fig. 5.10 - Use the keypad to select cursor movement