T/MonXM 4.7 User Manual

5-8

Section Five - Configuring Remote Access

Fig. 5.9 - T/Windows communications settings

The procedures for logging on and off T/MonXM while using

Remote Access are fundamentally identical to those described in

Section 16-61, Exit Monitor Mode. Refer to this section of the man-

ual for more information.

There are only a few differences in log on/log off procedures for

Remote Access users:

Users connected to the T/MonXM system by Remote Access Server

via LAN need log on and off only when starting the T/MonXM soft-

ware or after exiting Monitor Mode by logging off.

Users who are connected by standard Remote Access via serial port

connection must log on at the following times:

1. Whenever entering Monitor Mode.

2. After using CTRL-T to change terminal drivers — see following

page.

3. Remote users who are connected by modem must log on each

time a new modem connection is made.

You cannot log on with initials and a password already in use on the

host or another remote.

When using a modem to connect to the T/MonXM system, register

S7 on the modem must be set to 60 seconds. To set this register use

the command “ATS7=60.” This step is not required when using

T/Windows or T/RemoteW.

When using a modem to connect to T/MonXM, a Disconnect option

is available at log off.

Log On/Off