T/MonXM 4.7 User Manual

3-6

Section Three - Network Setup

Step Three

Fig. 3.7 - KDA Shelf Remote Device Definition Screen

Assign the data connection

1. From the Remote Parameters screen, press F6 to open the Data

Connection Assignment screen.

2. Press Tab to select the default list box for the Data Connection

field.

3. Highlight the data connection created for this port and press

Enter.

For the KDA example, your last step would be to provision the KDA.

1. Provision the KDA according to the instructions in Section M3-

7, File Maintenance, KDA Shelves.

2. Repeat for each KDA on the TCP/IP port.

3. Choose Master > Parameters > Remote Ports > F (Find) and

select the remote port you assigned for the KDA.

4. Press F1 to open the Remote Device Definition Screen.

5. Choose F)ind and select the ID number for the KDA.

6. Press Alt-F3.

7. Enter the KDA’s IP address and UDP port. This information must

exactly match the value assigned when the KDA was first con-

figured — see Figure 3.7 above.

8. Repeat steps 5 through 7 for each KDA.

Before uploading the provisioning file to the KDA, you must initial-

ize the system and enter Monitor Mode. Upload the file according to

the instructions in section M3-63.