T/MonXM 4.7 User Manual

UM-TMN-470

Section Three - Network Setup

3-5

Fig.3.5 - Remote Parameters screen with “No Data Connection” prompt

Step Two

Define the port usage

1. Choose Master > Parameters > Remote Ports > F (Find). Select a

port numbered 30 or higher. (Ports 30-500 are reserved for LAN

jobs.)

2. Press Tab to select the default list box for the Port Usage field.

3. Highlight DCP(F) Interrogator and press Enter. See Fig. 3.5.

4. In the DCP(F) Mode field, select X. Fill in all other fields as you

would for any DCP(x) port.

Note:

If you are setting up a remote port and the selected port usage

requires a TCP connection, T/MonXM will inform you by flashing

“No Data Connection” at the top of the screen — see Figure 3.6.

Fig. 3.6 - Assigning a Data Connection to the KDA LAN Job