T/MonXM 4.7 User Manual

UM-TMN-470

Section Three - Network Setup

3-1

Fig. 3.1 - Choosing Network Setup

Port 28 is reserved exclusively for configuring Ethernet input and

output. This usage can be halted by selecting Halted in the Port

Usage field or suspended by pressing F5, but no other usage can be

assigned to Port 28.

Port 28 controls the number and type of TCP ports available to

T/MonXM. Ethernet I/O must be set up on Port 28 to use LAN jobs

on Ports 30-500.

Step One: Network Setup

To configure T/MonXM to use Ethernet I/O, you must first assign

your T/MonXM system an IP address. To assign an IP address, fol-

low these steps.

1. Exit T/MonXM to W/Shell.

2. From the W/Shell Main menu, choose Network Setup.

3. From the Network Setup menu, choose Run Network Setup. (See

Figure 3.1.)

4. From the Network Setup Utility screen, select Edit Settings.

5. The Edit Settings screen will appear. (See Figure 3.2.) Enter IP

Fig. 3.2 - Editing Network Settings

Ethernet I/O

Section 3 - Network Setup

All LAN usage is set up

on Port 28 within

T/MonXM > Parameters >

Remote Ports.

Note:

see Software

Module 1 for LAN based

remotes — NetGuardian.