T/MonXM 4.7 User Manual

2-8

Section Two - Software Installation

Fig. 2.9. Successful installation message prompt

Run Installation

The installation process will only take a few minutes. The prompt

line at the bottom of the screen will list the files being installed and

prompt you to swap installation disks when necessary.

After a successful installation, you will see the screen shown in

Figure 2.9. Press any key to exit T/Install.

You will return to the W/Shell Main menu. From here you can run

your upgraded IAM or T/MonXM software or you can choose

Upgrades again to perform more installations.

Quit T/Install

After the upgrade is finished press Enter to select Quit. Then press

“Y” and remove the disk. Now you are ready to install updates, see

The following page for more information.

Step Four

Step Five

Note:

Program titles and

default destination paths

may vary according to

your IAM or T/Mon and

firmware versions.