T/MonXM 4.7 User Manual

2-6

Section Two - Software Installation

The latest T/MonXM version is installed from within your present

T/MonXM installation, using the included T/Install program.

Note:

This upgrade must be installed directly onto the internal hard

disk of the T/Mon or IAM. This software cannot be installed through

a remote or LAN connection.

To install the T/MonXM Version 4.6 upgrade, follow these step-by-

step instructions.

Exit to W/Shell

1. If T/MonXM is running in Monitor Mode, press F10 or Esc to

exit Monitor Mode. At the Log Off prompt, press R to return to

the Master Menu.

2. From the Master menu, choose Quit to exit T/MonXM.

3. Quit again to exit to WShell.

Step One

Step Two

Install W/Shell Upgrade

1. Insert the floppy disk labeled “WS XM or IAM UP-.”

Note:

T/Mon users should use disks labeled “WS XM UP” disk.

IAM users will should use disks labeled “WS IAM UP.”

2. After exiting T/MonXM, W/Shell will open to the TMonXM or

IAM Menu. Choose Quit to exit to the W/Shell Main menu.

3. Choose “Updates” from the W/Shell Main menu. See Figure 2.7.

4. The Update Menu prompt screen will appear. Press Enter to

launch T/Install.

5. Your T/MonXM system will read the disk and the T/Install pro-

gram will start.

6. The T/Install screen lists the program to be installed: IAM Shell

or XM Shell

7. Press Enter to choose the highlighted Install command.

Fig. 2.7. Choose Updates from the W/Shell Main menu.

Upgrading The

Software from

Floppy Disks

Note

: When a software

upgrade is installed, the

original on-line/off-line set-

tings and tagged alarms

will be lost.

Note:

The serial numbers

of your software upgrade

disks and T/Mon or IAM

must match. If you have

multiple T/Mons, make

sure that you use the cor-

rect disk set with each

machine.