T/MonXM 4.7 User Manual

UM-TMN-470

Section Two - Software Installation

2-5

4. When prompted, press “Y” to install each software upgrade. See

Figure 2.6.

Note:

“Unable to create directory” or “Directory already exists”

messages are a

normal

part of CD installations and do

not

indicate

an error.

5. Press any key to return to W/Shell.

6. Restart the computer.

On the

T/MonXM WorkStation

: Press CTRL-ALT-Delete

On the

IAM-5:

In the T/AccessMW menu bar, choose

Connection > Reboot Remote System.

Under normal circumstances installation will only need to be done

for software updates or newly ordered modules. However, the origi-

nal disks have been supplied with the workstation for archival or

emergency recovery procedures.

This procedure should only be done when a complete system recov-

ery is required, as with a hard disk failure. DPS technical support

should be notified before undertaking these steps.

To re-install IAM or T/MonXM from a CD follow the instructions

from sections 2-2 to 2-5. If you are re-installing IAM or T/MonXM

from floppy disks use the instructions on the following sections.

Fig. 2.6. Enter Y to install each software upgrade

Re-installing

T/MonXM (com-

plete system

recovery)

Note:

This procedure

does not restore your

database, but provides a

clean copy of the original

software.