T/MonXM 4.7 User Manual

2-2

Section Two - Software Installation

Upgrading The

Software from a

CD

When the T/MonXM system finishes booting, the W/Shell utility

will run. Highlight IAM or TMONXM on the menu and press Enter.

The program will load and the log on screen will be displayed.

Note:

The other menu items in W/Shell are used under the direction

of DPS Technical Support. The T/Mon comes from the factory with

all the software loaded. Software installation is required only to

install system upgrades or new software modules, or during system

recovery.

The T/MonXM upgrade is installed from within your present

T/MonXM installation, using the included T/Install program.

Note:

This upgrade must be installed directly onto the internal hard

disk of the T/Mon or IAM. This software cannot be installed

through a remote or LAN connection.

To install the T/MonXM Version 4.6 upgrade, follow these step-by-

step instructions.

Step One: Exit to W/Shell

1. If T/MonXM is running in Monitor Mode, press F10 or Esc to

exit Monitor Mode. At the Log Off prompt, press R to return to

the Master Menu.

2. From the Master menu, choose Quit to exit T/MonXM.

3. Quit again to exit to W/Shell.

Note: The serial num-

bers of your software

upgrade disks and

T/Mon or IAM must

match. If you have mul-

tiple T/Mons, make sure

that you use the correct

disk set with each

machine.

Step Two: Install W/Shell CD Support

Upgrade

1. Insert the floppy disk labeled “W/Shell CD Upgrade.”

2. After exiting T/MonXM, the W/Shell screen will open to the

TMonXM or IAM Menu.

3. Choose Quit to to exit to the W/Shell Main menu.

4. Choose “Updates” from the W/Shell Main menu, see Figure 2.2.

Fig. 2.2. Choose Updates from the W/Shell Main menu.

Note

: When a software

upgrade is installed, the

original on-line/off-line set-

tings and tagged alarms

will be lost.

Run T/MonXM

from W/Shell