xxxviii

Preface

February 7, 2006

T/MonXM 4.7 User Manual

IAM-5 and T/MonXM Workstation Port Interface Cartridges

Intelligent Controller Card

The Intelligent Controller Cards are switch addressable for 4

sequential ports at a time. The T/MonXM WorkStation will accept

up to 4 cards (limit of 16 ports).

D-PC-600-10A-00 Intelligent Controller Card

Four (4) Port Intelligent Controller Card for Ports 1-16 with RS232

Interface.

D-PC-602-10A-00 Intelligent Controller Card

Four (4) Port Intelligent Controller Card for Ports 1-16. Interfaces

available with the factory installation of up to four docking mod-

ules. Depending on interface requirements, the 602 Card can be

equipped with a variety of modules. The 602 Card docking modules

are described below.

D-PC-603-10A-00 Intelligent Controller Card for Pentium

T/MONs

Shorter version of the 602 for use in the short slots of TMON

Pentium mother boards. Uses one docking module and three hard-

wired RS232 or RS422/485 ports.

Docking Modules

D-PR-140-10A-00 212 Type 1200 Baud Internal Modem

Provides 212 type 1200 baud modem interface for the 602 card.

D-PR-145-10A-00 212 Type 2400 Baud Internal Modem

Provides 212 type 2400 baud modem interface for the 602 card.

D-PC-635-10A-00 202 Type 1200 Baud Internal 4-Wire Modem

Provides 202 Tone Modem interface for the 602 card.

D-PC-645-10A-00 RS232 Docking Module

Provides RS232 interface for the 602 card.

D-PC-655-10A-00 RS422/RS485 Docking Module

Provides RS422/RS485 interface for the 602 card.

In addition to the 602 card described above, versions are available

which have the equivalent of the docking modules hard-wired to the

card. See the DPS Catalog, or call us at (800) 622-3314 for details.

Uninterruptible Power System (UPS)

The Uninterruptible Power System (UPS) is line-interactive and

computer-grade quality. It has outstanding lightning and brownout

protection, and RF noise filtering. Because the software is commu-

nicating with the UPS, there is no break in power transfer between

line power and UPS usage. The UPS has two operational modes:

time-out and extended operation. Time-out mode allows a user

assignable amount of time, in minutes, after going to battery power

before T/MonXM will be shut down. This allows performance of an

orderly shutdown without corrupting alarm data files. Extended

operation mode allows T/MonXM to continue normal operation

until two minutes of battery operation remain before the it will be

shut down. In the event of an extended overnight power failure this

Fig. 1.7 - Intelligent

Controller Card

Fig. 1.8 - Docking module