Mediate Alarms To Your SCADA Master Using DNP3...

How This Application Works:

Equipment Used:

T/Mon NOC Alarm Master SCADA Master DNP3 Software Module

Mediate user selected legacy alarms to a SCADA Master using the DNP3 protocol. The goal being to give the manned SCADA master direct visibility of critical "after hour" events that are being monitored by the T/Mon NOC. Any alarm points collected by the T/Mon, regardless of their source or transport may be provisioned to report via the DNP3 responder module.

The DNP3 software module Software module enables T/Mon NOC to respond to a DNP3 alarm master on multiple ports (either Lan Virtual jobs or serial ports). It supports both discrete points and analog values. The analog values will use the two data byte plus flag format. The discretes and analogs will reside in different DNP3 addresses.

Mac Smith

Monitoring expert Mac Smith is here to answer your technical questions

What is your question?

Where should Mac send his answer?
Name:		Company Name:
Email:		Phone Number:
State:	**Outside United States Alabama Alaska Arizona Arkansas California Colorado Connecticut Delaware District of Columbia Florida Georgia Hawaii Idaho Illinois Indiana Iowa Kansas Kentucky Louisiana Maine Maryland Massachusetts Michigan Minnesota Mississippi Missouri Montana Nebraska Nevada New Hampshire New Jersey New Mexico New York North Carolina North Dakota Ohio Oklahoma Oregon Pennsylvania Rhode Island South Carolina South Dakota Tennessee Texas Utah Vermont Virginia Washington West Virginia Wisconsin Wyoming