Monitoring BiDirectional Amp Alarms with an Alarm Point Conditioner

How This Application Works:

Equipment Used:

Alarm Point Conditioner BiDirectional Amp

The solution features two choices for the Alarm Point Conditioner (APC).

Option #1 features the APC equipped with a Wire Wrap back panel. You will be able to terminate the alarms directly to the back of the unit via its wire wrap pins. The only tool you will need is a wire wrap gun.

Option #2 features the APC equipped with a connectorized back panel where you can terminate alarms via its screw down type connections. The only tool you will need is a phillips type screwdriver to screw down the alarms. The connectorized connections will make installation an easy process for terminating alarms.

The APC will convert up to 36 alarm points to common-referenced (ground) contact closures, which will then be monitored by your existing AlphaMax. The APC will be the ideally suited for interfacing with your TTL type alarms from your BiDirectional Amp. The difference between the two options are the alarm termination connections on the back of the unit.

Mac Smith

What else do you need to know? Send me your question right now:

My question is:

Where should I send your answer?
Name:		Company Name:
Email:		Phone Number:
State:	**Outside United States Alabama Alaska Arizona Arkansas California Colorado Connecticut Delaware District of Columbia Florida Georgia Hawaii Idaho Illinois Indiana Iowa Kansas Kentucky Louisiana Maine Maryland Massachusetts Michigan Minnesota Mississippi Missouri Montana Nebraska Nevada New Hampshire New Jersey New Mexico New York North Carolina North Dakota Ohio Oklahoma Oregon Pennsylvania Rhode Island South Carolina South Dakota Tennessee Texas Utah Vermont Virginia Washington West Virginia Wisconsin Wyoming